Diagnosis and laboratory monitoring of hemophilia A

Acquired hemophilia A (AHA) is a rare disorder in which autoantibodies against factor VIII (FVIII) lead to a bleeding phenotype that varies from life-threatening to no bleeding at all. Prolonged activated partial thromboplastin times (APTT) in patients with a bleeding phenotype should be investigated to rule out AHA and should never be ignored in a preprocedure patient. Most inhibitors in AHA are heat and time dependent, so mixing studies performed only on an immediate mix are not useful: both lupus anticoagulants and treatment with direct oral anticoagulants can coexist with AHA and confound the diagnosis. Assays for intrinsic coagulation factors and von Willebrand factor should always be performed, regardless of the results of mixing studies. A Bethesda or modified Bethesda assay should be performed to quantify any inhibitor, and if susoctocog alfa (rpFVIII) is available, then an assay for cross-reacting antibodies should also be performed. At diagnosis and until complete remission, if the FVIII in the patient sample is >5 IU/dL, heat inactivation should be performed before the inhibitor assays are performed. While there are no conventional tests available to measure the effects of FVIII bypassing therapies, newer therapies may require monitoring, or their effects may need to be considered when choosing appropriate assays. Measurement of rpFVIII requires a 1-stage clotting assay, and measurement of patient FVIII while on emicizumab requires a chromogenic assay that does not contain human FX. Close communication is required between the treating clinicians and the laboratory to ensure that the correct tests are performed while patients are receiving treatments.